Back in October we gave a quick overview of our Staccato HD holsters for Streamlight lights. This post goes deeper on the TLR-1: which lights fit, which HD models fit, and what you can order.
What fits
Both holsters are cut for the Streamlight TLR-1, TLR-1 HL, TLR-1 HP and TLR-1S.
That’s the classic TLR-1 family. The newer TLR-1 HL-X and HP-X do not fit these holsters. If you run one of those on your HD, leave a comment and let us know.
Pick the cut length for your HD:
- 3.60″: HD C3.6
- 4.00″: HD C4X, P4 and P4X
- 4.50″: HD P4.5
- Bisect IWB for Staccato HD with Streamlight TLR-1: from $105, with or without a mag carrier.
- M7 OWB for Staccato HD with Streamlight TLR-1: from $85, with or without a mag carrier.
Either one can be ordered with an attached mag carrier, and our Widecar double mag carrier is available separately.
Both are right-hand only for now. If you need a left-hand version, leave a comment below and let us know. For the HD itself, see our Staccato HD Support post.
About the light
We’ve run the TLR-1 HL through the Low Light Defense lab. In the Light Lab Comparator it measured 1,112 lumens but only 13,740 candela. The much smaller TLR-7 HL-X puts out about the same light, 1,103 lumens, and throws it harder at about 19,200 candela. So the TLR-1 HL is a flood: lots of light up close, less reach. It also ran 1 hour 49 minutes on two CR123As, 22% longer than Streamlight claims. It’s not a bad light; it just does a different job.
Need the light too? We stock the Streamlight TLR-1 HP, which fits these holsters. We also carry the TLR-1 HL-X and TLR-1 HP-X, but remember those two do not fit this holster. We also offer a discount when a light and holster are purchased together.
Not sure which holster fits your setup? Use the holster finder on the Werkz.com home page: pick Staccato and your HD model, then Streamlight and your light, and you’ll see the options we have available for you.
